PowerCore® C
PowerCore® H
Guaranteed values
Correlation table
Dimension conversion
Dimensions
Geometric tolerances
Other characteristics
Insulation types
Packing
Typical physical properties
Further processing hints
Search on tkes.com
Other characteristics and tolerances
Residual curvature
Edge camber
Max. distance for a sample 500 mm in length applicable for width > 150 mm
35 mm
Max. edge camber for a measuring length of 1,500 mm applicable for width > 150 mm
0.5 mm
Deviation from the shearing line due to internal stresses
Flatness (wave factor)
Max. measured gap within a strip length of 1,500 mm applicable for width
> 500 mm
1.0 mm
Max. wave factor applicable for width > 150mm
1.5%
The measuring methods for thickness and width are given in the product standards EN 10107 and IEC 60404-8-7.
All other measuring methods and definitions are given in EN10251 and IEC 60404-9.
The quoted values are in many cases better than those
specified in the EN or IEC-Norm.
Burr height (only for slit width)
Max. burr height
0.025 mm
Home
|
Company
|
Products
|
Publications
|
Press
|
Career
|
Contact
Printversion
top
Copyright by ThyssenKrupp Electrical Steel © 2008 |
Imprint/Disclaimer |
Last update: 04/09/2009
Copyright by ThyssenKrupp Electrical Steel © 2008 | Imprint/Disclaimer | Last update: 04/09/2009
Printversion
top