PowerCoreŽ C
Guaranteed values
Correlation Table
Dimension conversion
Dimensions
Geometric tolerances
Other characteristics
Insulation types
Packing
Typical physical properties
Further processing hints
PowerCoreŽ H
Search on tkes.com
Other characteristics and tolerances
Residual curvature
Edge camber
Max. distance for a sample 500 mm in length applicable for width > 150 mm
35 mm
Max. edge camber for a measuring length of 1,500 mm applicable for width > 150 mm
0.5 mm
Deviation from the shearing line due to internal stresses
Flatness (wave factor)
Max. measured gap within a strip length of 1,500 mm applicable for width
> 500 mm
1.0 mm
Max. wave factor applicable for width > 150mm
1.5%
The measuring methods for thickness and width are given in the product standards EN 10107 and IEC 60404-8-7.
All other measuring methods and definitions are given in EN10251 and IEC 60404-9.
The quoted values are in many cases better than those
specified in the EN or IEC-Norm.
Burr height (only for slit width)
Max. burr height
0.025 mm
Home
|
Company
|
Products
|
Publications
|
Press
|
Career
|
Contact
Printversion
top
Copyright by ThyssenKrupp Electrical Steel © 2008 |
Imprint/Disclaimer |
Last update: 04/09/2009
Copyright by ThyssenKrupp Electrical Steel © 2008 | Imprint/Disclaimer | Last update: 04/09/2009
Printversion
top